Alla resultat (1 945)

SparkFun-tillbehör We know this looks like a lot of our other LEDs but it's not! This is a PTH Addressable RGB LED with a WS2812 control IC built right into the LED. This PTH version is incredibly similar to its SMD cousin except it is a lot simpler to solder into yo

SparkFun-tillbehör The SparkFun Qwiic Dual Solid State Relay is a power delivery board that allows users to switch two AC loads from a low power microcontroller using the SparkFun Qwiic connect system. The board features two 25A/250VAC solid state relays that utilize t

SparkFun-tillbehör The name says it all on this one. An ATmega328 in DIP package pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to use an actual Arduino board.To get t

SparkFun-tillbehör The MicroMod Machine Learning Carrier Board combines some of the features of our SparkFun Edge Board and SparkFun Artemis boards but allows you the freedom to explore with any processor in the MicroMod lineup without the need for a central computer

SparkFun-tillbehör The SparkFun Inventor's Kit (SIK) has been and continues to be a staple for classrooms workshops and makerspaces for over 15 years. But when many hands share the same hardware over a semester small components inevitably get lost or broken. Instead

SparkFun-tillbehör Standard 22 AWG solid Brown hook up wire. Use this with your bread board or any project in which you need sturdy wire. Comes in small spools of 25'.

SparkFun-tillbehör This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm center positive barrel jack connector.The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easi

SparkFun-tillbehör This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.Dimensions: 6" lengthDocuments

SparkFun-tillbehör This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers.Dimensions: 6" lengthDocuments:D

SparkFun-tillbehör 6-Pin Chassis Connect Panel Mount

SparkFun-tillbehör Jumper wires are awesome. Just a little bit of stranded core wire with a nice solid female connector on either end. They have the flexibility of stranded wire but will fit directly onto male pin headers. The only downside to the standard jumper wires

SparkFun-tillbehör This is a SMD 4-pin right angle male header. We use this header on our Graphic LCD Serial Backpack.Pins have 0.1" spacing between rows and between pins.Documents:Dimensional Drawing