TPS259630DDAR

Texas Instruments
595-TPS259630DDAR
TPS259630DDAR

Tillverk:

Beskrivning:
Spänningsstyrenheter med hotswap 2.7-V to 19-V 85moh m 0.13-2A eFuse wit A 595-TPS259630DDAT

ECAD-modell:
Ladda ned den kostnadsfria Libary Loader för att omvandla denna fil för ditt ECAD-verktyg. Läs mer om ECAD-modellen.

På lager: 9 569

Lager:
9 569 Kan skickas omedelbart
Fabrikens ledtid:
6 Veckor Uppskattad tillverkningstid i fabriken för kvantiteter som är större än vad som visas.
Lång ledtid har rapporterats för denna produkt.
Minst: 1   Flera: 1
Enhetspris:
-,-- kr
Ext. pris:
-,-- kr
Est. Pris:
Förpackning:
Komplett Papprulle (beställ i multiplar av 2500)

Prissättning (SEK)

Antal Enhetspris
Ext. pris
Skärtejp/MouseReel™
7,39 kr 7,39 kr
5,29 kr 52,90 kr
4,76 kr 119,00 kr
4,18 kr 418,00 kr
3,90 kr 975,00 kr
3,73 kr 1 865,00 kr
3,59 kr 3 590,00 kr
Komplett Papprulle (beställ i multiplar av 2500)
3,43 kr 8 575,00 kr
3,35 kr 16 750,00 kr
† 58,00 kr MouseReel™-avgiften kommer att läggas till och beräknas i din kundvagn. MouseReel™-beställningar kan inte avbeställas eller returneras.

Alternativ förpackning

Tillverk: Artikelnummer:
Emballage:
Reel, Cut Tape, MouseReel
Tillgänglighet:
På lager
Pris:
8,84 kr
Min:
1

Liknande produkt

Texas Instruments TPS259630DDAT
Texas Instruments
Spänningsstyrenheter med hotswap 2.7-V to 19-V 85moh m 0.13-2A eFuse wit A 595-TPS259630DDAR

Produktattribut Attributvärde Välj attribut
Texas Instruments
Produktkategori: Spänningsstyrenheter med hotswap
RoHS-direktivet:  
Controllers & Switches
125 mA to 2 A
19 V
2.7 V
1 Channel
193 uA
- 40 C
+ 125 C
SMD/SMT
SO-PowerPad-8
Reel
Cut Tape
MouseReel
No
Märke: Texas Instruments
Monteringsland: CN
Distributionsland: US
Ursprungsland: CN
Ingångs-/matningsspänning - Max: 19 V
Ingångs-/matningsspänning - Min: 2.7 V
Fuktkänsliga: Yes
Produkttyp: Hot Swap Voltage Controllers
Serie: TPS2596
Fabriksförpackningskvantitet: 2500
Underkategori: PMIC - Power Management ICs
Enhetens vikt: 95,600 mg
Hittade produkter:
Markera minst en kryssruta för att visa liknande produkter
Markera minst en kryssruta ovan för att visa liknande produkter i denna kategori.
Attribut som valts: 0

Denna funktion kräver att Javascript är aktiverat.

CNHTS:
8542399000
CAHTS:
8542390000
USHTS:
8542390090
MXHTS:
8542399999
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.

TPS2596xx 2.7V to 19V eFuses

Texas Instruments TPS2596xx 2.7V to 19V eFuses with integrated FET hot-swap devices are highly integrated circuit protection and power management solutions in a small package. The devices provide multiple protection modes using very few external components and are a robust defense against overloads, short circuits, voltage surges, and excessive inrush current. The output current limit level can be set with a single external resistor. It is also possible to get an accurate sense of the output load current by measuring the voltage drop across the current limit resistor. Applications with particular inrush current requirements can set the output slew rate with a single external capacitor. For the TPS25962x variants, internal clamping circuits limit the output to a safe fixed maximum voltage (pin selectable) with no external components in case of an input overvoltage condition. The Texas Instruments TPS25963x variants allow setting a user-defined overvoltage cutoff threshold.